PFL1500
Vertical Shaft Compound Crusher
PFL series vertical shaft compound crushers do fine crushing and rough grinding in one chamber. Feed drops onto a throwing table, is flung by centrifugal force against the impact plates on the shell, breaks partly by collision with itself, then spirals down through the conical rotor gap where compression and shearing finish the job — the taper grades the work, so coarse rock stays in the chamber while fines leave. Feed up to 220 mm, product 3 mm and below at 70–90% passing. Eight sizes from PFL750 to PFL2500.
50–70t/h capacity
≤180 mmmax feed
132 kWdrive power
Specification
| Type | Vertical shaft compound crusher — throwing table, impact plates and conical rotor |
| Max. feed size | ≤180 mm |
| Product size | ≤3 mm, 70–90% passing |
| Shaft speed | 420–540 r/min, adjustable with the drive |
| Capacity | 50–70 t/h |
| Motor | 132 kW |
| Crushing stages | Multi-stage continuous chamber: impact, mutual collision, then compression and shear in the cone |
| Wear parts | Multi-alloy, high hardness and toughness; hammers reversible for a second life |
| Gap adjustment | Hammer-to-impact-plate gap set on site to trim the product curve |
| Mounting | Stationary on a four-leg steel frame with integral discharge hopper |
Figures are for reference. Final configuration is confirmed against your feed gradation, required product curve and site layout before the contract is signed.
Model variants
| Model | Feed (mm) | Output (mm) | Shaft speed (r/min) | Capacity (t/h) | Motor (kW) |
|---|---|---|---|---|---|
| PFL750 | ≤100 | ≤3 | 800–1350 | 8–20 | 45 |
| PFL1000 | ≤120 | ≤3 | 650–980 | 15–30 | 55 |
| PFL1250 | ≤150 | ≤3 | 510–770 | 35–45 | 90 |
| PFL1500 | ≤180 | ≤3 | 430–640 | 50–70 | 132 |
| PFL1750 | ≤200 | ≤3 | 420–540 | 70–100 | 160 |
| PFL2000 | ≤220 | ≤3 | 360–500 | 90–120 | 200 |
| PFL2300 | ≤240 | ≤3 | 330–450 | 120–160 | 250 |
| PFL2500 | ≤240 | ≤3 | 300–420 | 160–200 | 355 |
Same machine, different configuration: the model code is set by the figures below. Quote the model code when you enquire — drawings, wearing parts and mounting are shared across the variants listed.
Typical applications
- Cement raw meal and clinker
- Shale, glass, ceramic and bluestone
- Soft iron ore, limestone and gypsum
- Blast furnace slag, lump coal and manufactured sand feed